Upgrading electrical panels
We replace outdated load centers with new panels that have enough spaces for modern circuits. We coordinate with the utility for the service disconnect and label every breaker clearly.
Springfield is a short drive west, and we serve many homeowners there with panel upgrades and whole house rewiring. We also get calls for outlet and switch repairs in homes that are being updated.
4.9 stars on Google
From 108 Google reviews.
Local, and close by
Covering Alexandria, VA and the surrounding area.
Free estimates
Tell us what needs doing and we will come out and take a look.
Springfield's mix of mid-century ramblers, split-levels, and newer townhome developments keeps our crew busy with electrical work that matches the age of the homes. Many of these houses were built with panels and wiring that are now undersized for modern loads, and the humid Virginia summers push older air conditioners and appliances hard. The rolling terrain and mature trees also mean service drops and exterior wiring take a beating from storms, so we spend a good part of our time here on repairs that keep the power on safely.
We load up our van each morning in Alexandria and head west on Franconia Road or the Fairfax County Parkway, depending on where the job sits. Because we're only a short drive away, we can be on site quickly and still carry the full range of parts for panel swaps, rewiring, and outlet repairs. We work inside the home, lay down floor protection in hallways and rooms we pass through, and vacuum up drywall dust before we leave. Being local means we know the typical layouts and can often spot the original wiring style before we open a wall.
JM & Sons Electrical Services works across Alexandria, VA and the surrounding area, so a crew is never far from Springfield. Call (703) 725-8508 or request a free estimate and we’ll come out and take a look.
Older Springfield homes often have 100-amp panels that struggle with modern appliances. We replace them with higher-capacity panels and bring the service entrance up to current load requirements.
Split-levels and ramblers from the 1960s and 1970s may still have aluminum branch circuits or cloth-insulated wiring. We strip out outdated systems and run new copper to every outlet and switch.
Loose receptacles, broken switches, and two-prong outlets are common in this area's older homes. We replace them with grounded devices and tighten connections to prevent overheating.
Thunderstorms and falling branches can knock out circuits or trip breakers. We trace the fault from the panel to the affected room and repair or replace damaged wiring and fixtures.
We replace outdated load centers with new panels that have enough spaces for modern circuits. We coordinate with the utility for the service disconnect and label every breaker clearly.
We pull out old cloth-covered wire and aluminum branch circuits, then run new Romex through walls and attics. We cut openings carefully, patch drywall, and leave the house clean.
We replace worn receptacles, dimmer switches, and three-way switches that no longer work properly. We check for loose connections and upgrade to tamper-resistant devices where needed.
This neighborhood is packed with 1950s and 1960s ramblers and split-levels. We're often called in to upgrade panels and add grounded outlets in kitchens and bedrooms that still have original wiring.
The area around the town center mixes older single-family homes with newer condos and apartments. Work here includes panel changes in older units and troubleshooting intermittent power issues in mixed-use buildings.
Homes on larger lots along the edges of Springfield often have long service runs from the road to the house. We replace underground feeds and upgrade panels where the existing service is too small for added outbuildings.
Most panel upgrades and rewiring projects in Springfield require a permit from Fairfax County. The homeowner or the contractor pulls the permit, but it's the homeowner's responsibility to confirm that the work is inspected and approved.
When upgrading a panel, the service entrance and grounding must meet current code. Your county building department can tell you what clearances and grounding methods apply to your specific setup before you schedule the work.
4.9 average from 108 Google reviews
“Julio helped with last-minute commercial electrical work during a company move. Very professional, responsive, knowledgeable and easy to work with. Fair pricing and excellent service. I highly recommend JM & Sons Electrical Services.”
“After a week of trying to figure out why my dryer wasn't working, I finally learned it was a bad circuit breaker, and I needed it fixed last-minute. I called JM & Sons, and the owner, Julio, came out ASAP. He was incredibly professional, knowledgeable, and respectful. He fixed the issue quickly and explained everything as he worked.”
“Julio was so responsive! I heard back promptly after submitting a request via the website and he came out to the house a couple days later to review our project. After reviewing the project, Julio said he could get the lights and have his colleague David come back that afternoon to install. It was great to get the project done in one day and we are VERY happy with the results!”
“The technician arrived on time. David did an excellent job. The before and after pictures are a testament to how well the job was completed. Thank you Julio and the JM Electric team for making this an awesome experience.”
“We used JM & Sons for some upgrades we needed to do on our house and were not disappointed! They did a great job in a timely manner. Will definitely keep them in mind for future projects when we need them.”
Call us or fill out the form and we will get back to you quickly. We serve Alexandria and the surrounding area.